Eddie Martin Band Tech Spec and Channel List 2017
Eddie Martin Band
2017 Tech Spec and Channel List
Please take the time to read the following Technical Information. If there are any problems with the following, please contact the bandʼs FOH Engineer or, if not specified, Band Manager, Martin Fairclough on 07974120418 prior to show day.
Thank you for your time and assistance.
PA:
The band requires a 4/3-way PA system that provides approximately 1k per 100 people. The system must have 31 band graphic EQ (BSS, KT, Audient or similar) on FOH and all monitor sends that our engineer will have access to. These graphic settings are not to be altered for any support acts. The system should provide consistent full range coverage across the entire venue.
Preferred PA : L-Acoustics, D&B, BMS/Coda or Nexo.
FOH:
Please position FOH at FOH. Not at the side of stage or in the corner of the room if at all possible please.
Front of house console should have a minimum of 24 mono channels and 4 stereo channels, with 8 subgroups and 6 aux sends (8 if monitors are controlled from FOH position) switchable pre/post fader. 3 aux sends shall be made available to the engineer for use of personal outboard effects.
We prefer analogue consoles if at all possible please.
Preferred FOH Consoles:
Analogue: Midas XL2, XL3, XL4, Heritage, Soundcraft MH4, Series Four.
Digital: Digidesign VENUE D-SHOW Profile, Yamaha PM5D, Soundcraft Vi6.
If an analogue desk is provided we will also require:
2 x Reverb units (TC Electronics Reverb 4000/Lexicon PCM91 or similar)
1x Delay unit (TC Electronics D-Two or similar)
4x Gates (Drawmer, BSS, Klark Teknik)
6x Compressors (DBX 160A, Klark Teknik, BSS)
Monitors:
We are not travelling with a monitor engineer.
If monitors are mixed from stage then a competent monitor engineer should be
available at no extra cost to the band.
3 bi‐amplified mixes are required:
1 pair of wedges – downstage right
1 pair of wedges – downstage left
1 drum fill, with subwoofer – upstage centre
2 side fills – stage left and right (if applicable. eg. large outdoor festivals)
Each mix should have itʼs own 31 band graphic equalizer for elimination of feedback on stage.
If monitors are to be mixed from stage, venue shall provide a sober, professional engineer
responsible for operation of monitors throughout sound check and performance.
Monitors should be zeroed and then rung out prior to soundcheck.
| Ch. | Input | Mic | Stand | Insert |
| 1. | Kick | Beta52A | Short | Gate 1 |
| 2. | Snare | Beyer201/SM57 | Short | Comp1 |
| 3. | Snare Bottom | Beyer201/e904 | Short | Gate2 |
| 4. | Hats | SM81 | Short | – |
| 5. | Tom 1 | e904/e604 | – | Gate3 |
| 6. | Tom 2 | e904/e604 | – | Gate4 |
| 7. | OH/L | C414 | Tall | – |
| 8. | OH/R | C414 | Tall | – |
| 9. | Guitar | e906/e609 | Short | |
| 10. | Harmonica amp | MD421/M88 | Short | |
| 11. | Vocal | SM58 | Tall | Comp2 |
| 12. | Bass Amp | DI | – | |
| 13. | Room reverb return | – | – | – |
| 14. | Plate reverb return | – | – | – |
| 15. | Delay Return | – | – | – |